1 / 3
Lenovo m720q bracket for Connectx-3 single 10G card — zdjęcie 1
1 / 3

Lenovo m720q bracket for Connectx-3 single 10G card

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a simple bracket to install a Mellanox Connectx-3 EN mcx311a in a lenovo tiny m720q or m920q

Ocena
0 / 5
Polubienia
4
Pobrania
42
Wydruki
0
Wyświetlenia
326
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Share Alike

This is a very simple bracket to install single port Mellanox Connectx-3 card into a Lenovo M720q tiny. The bracket does not require any support, once printed, snap or cut off the part on the right, stick it through the protruding pins and weld in place with either a soldering iron or any heated instrument. It's designed to allow placement of two holding screws, one from the side of the case and one in the back from the inside. You will likely need to do some minor trimming with a scalpel blade to have a perfect fit for the bracket in the case.

This bracket was designed with large airflow holes, to be used in tandem with Matthew Neuforth's fan shroud. Since the connectx-3 cards are somewhat power hungry, I would advise against using them in the Mx20q machines without additional cooling.

Tagi