1 / 2
Aluminum Extrusion End Cap - 30mm x 30mm — zdjęcie 1
1 / 2

Aluminum Extrusion End Cap - 30mm x 30mm

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

An end cap for aluminum extrusion - 30mm x 30mm

Ocena
0 / 5
Polubienia
6
Pobrania
66
Wydruki
0
Wyświetlenia
124
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Share Alike

An end cap for 30mm x 30mm aluminum extrusion.

I printed it in PLA at 0.2mm layer height, and it was plenty strong enough.  The part is stout enough that I don't think there's much risk of pieces getting snapped off.

I've tested putting it on and taking it off about 10 times, and it still fits snugly after all that.  Of course depending on your exact extrusion, your mileage may vary.

If you want to remix for your specific extrusion, check out the OnShape file here, or the STEP file included in the files section.

Tagi