1 / 1
Sytools Beast base foot for knife sharpener
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount a Sytools or Sy Tools Beast knife sharpener to a board if you got the cheap simple version
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 305
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I bought the cheaper simple version of SyTools Beast without the standoff table stand. It's a bit inconvenient to use, so I made this simple base with standoffs in OpenSCAD. Attaching it to a board makes it easier to clamp onto a table.
Print instructions:
- PLA or whatever
- I printed in 0.2mm layer height
- Preview the screw hole above the hex nut hole gets printed correct. I made some final adjustments to this before publishing but after printing the one I'm using now.
Parts I used:
- 2pcs M8 Flat head or socket countersunk screw 30mm
- 2pcs M8 hex nut
- 1pc M8 washer for countersunk / flat head screw.
- 6pcs 3x16mm screw for wood
- 1pc scrap piece of wood board
Assembly:
- Make sure you place the standoff on a board so that the knife will be able to rotate. That is don't mount it too far away from the front side.
- Think about how you will secure the stand if you are using clamps, make sure there is enough space on the bottom board.