1 / 1
ProtoXtruder 2.0 reinforced idler arm with 1 mm increased gap — zdjęcie 1

ProtoXtruder 2.0 reinforced idler arm with 1 mm increased gap

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Use a stronger idler arm for your ProtoXtruder 2.0 (great for heated chambers)

Ocena
0 / 5
Polubienia
11
Pobrania
49
Wydruki
0
Wyświetlenia
242
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This model is a stronger idler arm for the ProtoXtruder 2.0, with a 1 mm increased gap between the idler and the extruder body!  This solves two problems that I have with the original idler arm:

  • The arm warps when heated in a heated chamber over 65C.  The thicker arm provides more reinforcement, which fixes this problem.
  • When printing in a heated chamber over 65C, the filament near the extruder gears can get soft and get squished.  The additional 1 mm gap between the idler arm and the extruder body lets the extruder squeeze the filament a little more when it gets soft to continue the print (instead of pinching the filament and making it slip, making a print fail).

It is designed to be a direct replacement for the original idler arm.  Remove the old, swap the gear, install the new!

Tagi