Phone holder for Ikea Vattenkar monitor stand (updated)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A phone holder for Ikea Vattenkar monitor stand – three variants for various usage cases
- Ocena
- 5 / 5
- Polubienia
- 5
- Pobrania
- 51
- Wydruki
- 1
- Wyświetlenia
- 272
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Simple phone holder with mounts prepared for attachment to Ikea's Vattenkar monitor stand. The bottom part (the feet) includes a space to allow for wired charging. The stand can hold a phone up to 11 mm thick.
Included in this printable are 3 versions:
- A: full length (5 cm) holder
- B: shortened (3 cm) holder
- C: almost top mounted version that allows for better access to the shelf
Materials
Printed originally on Prusa Mini+ with PLA (Prusament), printed on the side with supports for the gap part, took 1 hour to print (profile 0.2 mm structural with gyroid infil for better strength).
Recommendations
The mounting gap is set to 7.75 mm to fit the wood with a decent tolerance. For a bit more snug fit I have fitted the top part with two small (D5 x 0,5 mm) rubber stickers/pads that are usually used for feet of flat prints to prevent them from sliding on the table.