MikroTik Antenna Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Convert the proprietary antenna holes in MikroTik hardware cases to accommodate an SMA connector, or plug an open hole.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 118
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Share Alike
If you have a MikroTik device with knock-outs for antennas, these models will let you:
- Adapt the hole to accommodate a standard SMA connector
- Or plug the hole completely
I couldn't find anything like this, so I designed one myself. However, I was inspired by @audris's model, MikroTik RouterBoard case antenna adapter, which uses a thread-and-nut design to hold the adapter in the knock-out – way better than designing one to snap in!
Note: these may be a rather tight fit, so I'd recommend scaling the nut at 102-105% (X and Y only, leave Z at 100%) to give a little more tolerance to the threads. Alternatively, if you have a M16x2 tap and die, you can just chase the threads to make them fit more precisely.
Tip: print with a 0.1mm layer height to make the threads smoother.