MikroTik Antenna Adapter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Convert the proprietary antenna holes in MikroTik hardware cases to accommodate an SMA connector, or plug an open hole.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 20
- Makes
- 0
- Views
- 118
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Share Alike
If you have a MikroTik device with knock-outs for antennas, these models will let you:
- Adapt the hole to accommodate a standard SMA connector
- Or plug the hole completely
I couldn't find anything like this, so I designed one myself. However, I was inspired by @audris's model, MikroTik RouterBoard case antenna adapter, which uses a thread-and-nut design to hold the adapter in the knock-out – way better than designing one to snap in!
Note: these may be a rather tight fit, so I'd recommend scaling the nut at 102-105% (X and Y only, leave Z at 100%) to give a little more tolerance to the threads. Alternatively, if you have a M16x2 tap and die, you can just chase the threads to make them fit more precisely.
Tip: print with a 0.1mm layer height to make the threads smoother.