1 / 3
X5SA Z Rod Spacers and Pillow Blocks — zdjęcie 1
1 / 3

X5SA Z Rod Spacers and Pillow Blocks

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Two simple models to make the Z axis tighter on the Tronxy X5SA Pro

Ocena
0 / 5
Polubienia
0
Pobrania
4
Wydruki
0
Wyświetlenia
65
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

After suffering for days thinking I had a severely warped bed I finally noticed my Y rails were sagging due to a combination of pressure from the shorter than ideal Z axis linear rods, unsupported Z axis lead screw and probably just the weight of the moving gantry.

So I made those 2 simple models:

A small disc spacer for the Z-rods, they're 4mm tall and that's what I needed but if you need less just sink it into the bed a little, I find these are better a bit tight than loose as the plastic will compress a little making everything alright, they don't need any aditional hardware to be installed, but you might need to disassemble a bit.

A pillow block that goes on top of the Z stepper motors, you will need at least 2 m3x12mm screws to mount it and a F8-16M thrust bearing for each side.

As you can see, they worked wonders, now either my Y axis is just as warped as my bed or everything is as straight as possible, either way, I'm happy.

Tagi