X5SA Z Rod Spacers and Pillow Blocks
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Two simple models to make the Z axis tighter on the Tronxy X5SA Pro
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 4
- Makes
- 0
- Views
- 65
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
After suffering for days thinking I had a severely warped bed I finally noticed my Y rails were sagging due to a combination of pressure from the shorter than ideal Z axis linear rods, unsupported Z axis lead screw and probably just the weight of the moving gantry.
So I made those 2 simple models:
A small disc spacer for the Z-rods, they're 4mm tall and that's what I needed but if you need less just sink it into the bed a little, I find these are better a bit tight than loose as the plastic will compress a little making everything alright, they don't need any aditional hardware to be installed, but you might need to disassemble a bit.
A pillow block that goes on top of the Z stepper motors, you will need at least 2 m3x12mm screws to mount it and a F8-16M thrust bearing for each side.
As you can see, they worked wonders, now either my Y axis is just as warped as my bed or everything is as straight as possible, either way, I'm happy.
