u-blox CAM-M8Q Shark Fin Antenna Case – with Magnet Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Shark fin case for u-blox CAM-M8Q GPS antenna, ASA print, magnet mount, fits GPS UDP Tracker setup.
- Ocena
- 0 / 5
- Polubienia
- 16
- Pobrania
- 231
- Wydruki
- 0
- Wyświetlenia
- 792
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
u-blox CAM-M8Q Shark Fin Antenna Case – with Magnet Mount

This enclosure is designed for the u-blox CAM-M8Q GPS module with integrated patch antenna.
It features a durable shark fin–style housing optimized for outdoor and automotive use.
The model was created as part of the GPS UDP Tracker project and is intended to be used together with:
- Firmware and documentation: GPS UDP Tracker on GitHub
- Companion enclosure: Wemos D1 Mini (ESP8266) Case with USB-C and 4-pin JST Connector on Printables
The case includes a recess for a rubber-coated Ø22 × 6.4 mm neodymium magnet, allowing quick magnetic mounting to metal surfaces.
It also features a 4-wire cable feedthrough for cables up to 5 mm in diameter.
After installation, the two parts should be glued together for a weather-sealed, permanent assembly.
Printing Recommendations
- Material: ASA (for UV and weather resistance)
- Layer height: 0.2 mm
- Top layers: 5
- Bottom layers: 5
- Walls (perimeters): 4
- Infill: 40 %
- Supports: Where needed
- Orientation: STL files are already positioned correctly for printing
Assembly Notes
- Insert or glue the magnet into the bottom recess.
- Route the 4-wire cable through the feedthrough opening.
- Apply silicone sealant or a rubber grommet if waterproofing is required.
- Once the GPS module is in place, glue both halves together using ASA solvent adhesive or epoxy.
Design Info
- Optimized for the u-blox CAM-M8Q module
- Magnet recess fits Ø22 × 6.4 mm rubber-coated magnet
- Cable feedthrough supports up to Ø5 mm cables
- Designed with ASA tolerances for outdoor reliability
- Two-part glued design for sealed assembly