MONOBLOCK v2.12 1.75mm duel conversion for Ultimaker 1, 2, 2+, connect extended
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Monoblock for Ultimaker 1, 2, 2+
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 84
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
Monoblock for Ultimaker 1, 2, 2+
This block will not only enable you to convert your standard Ultimaker print head from 2.85mm filament to 1.75mm filament, but will also enable structural integrity and rigidity for higher quality prints.
Once printed, it is highly recommended all holes are drilled to OEM specs. Bearing holes must be drilled to 12mm for best fitment of bearings. The clamping holes must also be drilled to 3mm to ensure smooth and easy installation. Bowden coupler holes must be drilled to 5mm then tapped to M6 thread.
Clamping bolts used are M3x70 (found on amazon) Bowden coupler connectors are 4mm x m6 thread.
Print Upside-down for best results. No support needed infill 100% recommended for max strength and rigidity.
As always, I look forward to seeing your prints and feedback.
Category: 3D Printer Parts