10" 1U 3 x SBC (Raspberry Pi 3, Raspberry Pi 4, Raspberry Pi 5, Orange Pi 3B)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fit 3 SBCs in 1U 10" rack space. Made to handle Orange Pi 3B with NVMe drive underneath. But will also fit Raspberry Pi
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 251
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
I was inspired by other solutions here, but I thought I could do something similar, but better :)
Whats unique with my design:
- Designed for printing without overhangs or support
- Designed for heat-inserts (voron style)
- All three face plates are the sameI was inspired by other solutions here, but I thought I could do something similar, but better :)
Whats unique with my design:
- Designed for printing without overhangs or support
- Designed for heat-inserts (voron style)
- All three face plates are the same
Tips & Trix
If using Rpi PoE-hat, you should probably screw in the board with 2.5x9 standoffs
If USB power connector is interfering with the next SBC, flip the middle SBC upside down, they are symmetric like that.
Printing
No supports, resolution doesn't matter, I did 0.2 for holders and 0.3 for plate
Print 3 sbc-holders of your choice, they are needed for stability.
Print the 10" plate
Hardware for full rack
- 6x inserts, M3 x 5 x 4mmM3 x 5 x 4mm (Voron style)
For the plate to be able to hold holders - 6x M3x6 (or 8, 10, whatever, countersunk preferred)
To screw the holders to the plate - 6x M2.5x6 (or 8, 10, whatever)
To screw the SBCs to the holders