MagSafe iPhone Stand (Sand-Fill for Extra Weight) with Swappable Front Insert
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Nordic MagSafe stand with sand-fill weight + cork-ready base. Press-fit puck, hidden cable, swappable insert.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 177
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted a MagSafe stand with a simple look, extra weight, and great grip. After a few iterations this is the result: a Nordic profile with an internal sand-fill cavity for weight and underside grooves for gluing cork/TPU/EVA anti-slip pads.
Model is printed and tested withe PLA
Important (no supports inside):
If you plan to fill it with sand, do not generate supports inside the cavity. Use support blockers / paint-on supports so only the small areas that need it get support.
Printing notes
- Minimal supports at the top of the arch around the MagSafe pocket.
- Light support on the underside where the grooves/opening are (for the cork pad).
- Also add light support on the top lip inside the insert slot (where the front insert slides in). Use support blockers so nothing is generated inside the sand cavity.
- Everything else prints cleanly.
Sand fill
- I used jointing sand / paver sand (very fine ).
- Weight: ~142 g filled, ~65 g empty.
- Filling is a bit fiddly but works fine—tap to settle the sand.
- Once filled, glue the small round ring/plug over the hole to seal it.
Assembly
- Cable & puck: simple press-fit.
- Puck type: designed around the MagSafe Charger (2nd generation).
Add cork/TPU to the underside grooves for better grip.
I plan to upload more front inserts over time. If you’d like to design your own, the insert pocket is
W 48.8 mm × H 24.4 mm × T 2.0 mm. Leave 0.2–0.3 mm clearance for a snug press-fit