MagSafe iPhone Stand (Sand-Fill for Extra Weight) with Swappable Front Insert
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Nordic MagSafe stand with sand-fill weight + cork-ready base. Press-fit puck, hidden cable, swappable insert.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 11
- Makes
- 0
- Views
- 178
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted a MagSafe stand with a simple look, extra weight, and great grip. After a few iterations this is the result: a Nordic profile with an internal sand-fill cavity for weight and underside grooves for gluing cork/TPU/EVA anti-slip pads.
Model is printed and tested withe PLA
Important (no supports inside):
If you plan to fill it with sand, do not generate supports inside the cavity. Use support blockers / paint-on supports so only the small areas that need it get support.
Printing notes
- Minimal supports at the top of the arch around the MagSafe pocket.
- Light support on the underside where the grooves/opening are (for the cork pad).
- Also add light support on the top lip inside the insert slot (where the front insert slides in). Use support blockers so nothing is generated inside the sand cavity.
- Everything else prints cleanly.
Sand fill
- I used jointing sand / paver sand (very fine ).
- Weight: ~142 g filled, ~65 g empty.
- Filling is a bit fiddly but works fine—tap to settle the sand.
- Once filled, glue the small round ring/plug over the hole to seal it.
Assembly
- Cable & puck: simple press-fit.
- Puck type: designed around the MagSafe Charger (2nd generation).
Add cork/TPU to the underside grooves for better grip.
I plan to upload more front inserts over time. If you’d like to design your own, the insert pocket is
W 48.8 mm × H 24.4 mm × T 2.0 mm. Leave 0.2–0.3 mm clearance for a snug press-fit