IKEA 365+ Dry Food Container Stackable Cupboard Organizer

🏗 Introduction

Turn your IKEA 365+ dry-food containers into a modular pull-out drawer system!

These printed holders keep each container securely in place while letting you slide out the bottom one without disturbing the stack above.

The design interlocks vertically and horizontally, forming a stable grid of drawers that makes your pantry or cupboard tidy and easy to access.

Perfect for anyone who loves IKEA hacks, organized storage, and clever 3D-printed solutions.

🧰 Build Instructions

Print one holder for each IKEA 365+ container you want to store.

Clean up the prints — remove supports and any light stringing around the interlock areas.

Stack or connect the modules:

They slot together vertically using the built-in interlock system.

You can also arrange them side by side to form a stable grid.

Insert your IKEA 365+ boxes — they should slide in smoothly but sit snugly in place.

Test by pulling out the bottom container — the design keeps the upper ones steady.

You can expand or rearrange the grid anytime — it’s fully modular!

🖨 Print Tips

Supports: Only minimal supports are needed — just under the overhang for the vertical interlock.

Material: PLA or PETG both work well; PETG recommended for kitchen use.

Layer height: 0.2 mm for a clean fit.

Infill: 15–20% is plenty; the design is self-supporting and rigid.

Orientation: Print upright (base flat on the bed).

No post-processing required, but a light sand or file around the interlocks can improve stacking tolerance.