1 / 1
Vacuum Hose Adapter 1-3/4" to Dewalt Table Saw and Chop Saw — zdjęcie 1

Vacuum Hose Adapter 1-3/4" to Dewalt Table Saw and Chop Saw

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Connect your 1-3/4" shop vac hose to a tool with a ~2-1/4" INNER diameter or ~1-5/8" OUTER diameter port

Ocena
0 / 5
Polubienia
1
Pobrania
12
Wydruki
1
Wyświetlenia
76
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial

Double-check print orientation before printing! There's a ledge inside where the two different inner diameters meet; you'll get better results with the thicker end down.

This 1-¾" vacuum hose adapter is based on an older (~2010) Ridgid shopvac, and was designed to fit both (not simultaneously) a Dewalt table saw and chop saw - also a few years old so verify your own diameter rather than just the model numbers below.
It can be used to join any ~1-¾" hose to any 2-¼" inner diameter or 1-5/8" outer diameter port.

The design is a cylinders with 3x tapers to allow clearance at the opening and a good sealed interference fit as you press in the hose and/or adapter.

Shop vac model: Ridgid WD1636 Wet/Dry Vacuum, 1-¾" outer diameter hose
Table saw model: Dewalt DW745 Compact Portable Jobsite Table Saw, 2-¼" inner diameter port
Chopsaw model: Dewalt DWS713 10 in. Compound Single Bevel Miter Saw, 1-5/8" outer diameter port

Tagi