3D printer LED Mount for Flashforge Adventurer 5X (AD5X) with Enclosure — Switch controllable and Reversible Installation
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
3D printer LED light mount with manual switch for Flashforge Adventurer 5X (AD5X) enclosure. Easy, reversible installati
- Ocena
- 3,667 / 5
- Polubienia
- 54
- Pobrania
- 396
- Wydruki
- 1
- Wyświetlenia
- 3420
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
LED light mount for Flashforge Adventurer 5X (AD5X) 3D printer enclosure.
The Flashforge Adventurer 5X is a great printer, but the lack of internal lighting in the enclosure makes it difficult to monitor prints. The official LED module has some limitations: it can only be controlled through the software, and the light position is not always ideal.
This model solves the problem efficiently and reversibly:
ADVANTAGES:
Compatible with official Flashforge LED strip
Perfect fit for the official enclosure
Does not modify the printer itself — fully reversible
Allows manual LED control via a dedicated switch
Clean and professional appearance
Materials & Recommendations
Print in PETG (recommended) or PLA
Flashforge 12 V LED strip - https://a.aliexpress.com/_ExidWwy
1 × self-locking 12/24V 12 mm switch - https://a.aliexpress.com/_EHB3sdE
3 × 4.8 mm female terminal connectors - https://a.aliexpress.com/_Ez6ODPS
1 × 4.8 mm male terminal connector - https://a.aliexpress.com/_Ez6ODPS
2pair x JST-XH 2,54mm connectors - https://a.aliexpress.com/_EwZDOnq
Ensure correct polarity before powering the LED or the printer
Assembly Instructions
1st step - Print the models
2nd step - Screw the LED strip to the enclosureLED.stl mount.
3rd step -Attach a mini JST male connector to the LED strip, on the side near pillar D3.
4th step -Place the mount between pillars A3 and D3 of the enclosure.
5th step - Connect the cable to the printer board at the back of the printer.
6th step -Run the wire along the cable track to the enclosure door using cableFixing.stl.
7th step -Drill a 12 mm hole in pillar D3 (approximately at the center) and install the switch.
8th step -Connect a mini JST female connector to the wire from step 6
9th step -Connect the negative (black) wire of the JST female connector to the negative of the JST male connector from the LED strip, and connect both positive (red) wire to the switch.
10th step -Use d3CableFixing.stl and d3TOPCableFixing.stl to secure the wires at the junction of pillar D3 and D2 for a tidy finish.
