Vizio Soundbar Low Profile hanging Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Low profile mount for my Vizio M51 Soundbar designed to secure under a mantel (or wherever)
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 112
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This a low profile mount I designed to mount my Vizio M51 (M51a-H6) Soundbar underneath my new mantle I recently finished. Print TWO pieces. Fit, position, and measure - IDEALLY these should be positioned centered to the 2 recessed areas of the back of the soundbar to be able to snap them into place easily. It is possible to mount the brackets then slide the soundbar thru if you have enough clearance on either side but I did not. Once mounted the brackets are meant to grab the top front “lip” of the soundbar then have the soundbar rotated into place while flexing the bottoms down and under the bar to snap into place.
This build has to have some flex to it to be able to slip the bottom “tabs” under. I used Matte PLA which worked just fine.
This is also about as low profile as I could come up with so there is NO ACCESS to the buttons on top without taking the bar off the brackets. I never use the physical buttons and only use remotes so this wasn't a concern for me.
BE SURE to print 2 on their sides
- PLA
- 3 Outer walls
- I did 20% TPMS-D infill
- Archimedean Chords top and bottom pattern (because it must flex this seemed to hold better)