Gigabyte Eagle 3080 Ti Exhaust Duct
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Diverts exhaust from the GPU out of the case. Probably will not make your GPU run cooler, but lowers case temps.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 266
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Public Domain
Introduction
A duct to divert GPU exhaust directly out of your case. This will possibly raise your GPU temperatures by up to 2ºC in a well cooled case, but will lower your case temperatures. In a poorly ventilated case, it may lower your GPU temperature if you are lucky.
Print this out of at least ABS. PLA is going to slowly warp/melt with your hot GPU blowing on it, and even PETG may over an extended period of time. I printed mine out of PA6 CF and it has naturally been holding up very well.
When installing this part, it pretty much solely relies on the one end clipping onto the three holes cut in the GPU board and the other end can either hang out in a more narrow case, or be secured with some tape or zip ties if needed.
Notable Printing Considerations
- This is a part subject to high temperatures. It is imperative that the plastic used can handle temperatures that your GPU can eject, which would typically be ~45ºC but could approach much higher temperatures.
- The adapter parts are quite large and may be subject to warping without a suitable enclosure or poor bed adhesion.
If you are sufficiently happy with how this design has worked out for you, please consider sending a donation my way if you are able: https://buy.stripe.com/bIY4i488N84rcCY3cc