BESTA to SKADIS Mount Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An adapter to cleanly mount a SKADIS pegboard inside a BESTA cabinet without any extra hardware or holes.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 293
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This mounting adapter allows you mount a 22x22in (56x56cm) SKADIS pegboard inside a 23x25in (60x64cm) BESTA frame without any modifications to either the frame or pegboard.
It provides an offset standoff that accepts the standard SKADIS mounting “bolt” and is the same height as the “floating” standoffs included for use on the bottom of the SKADIS board. The adapter works by hooking onto the washer used in securing a BESTA frame to the wall.
Tolerances are targeted to align with the washer spacing when mounting the frame via the BESTA suspension rail, but also provide for some adjustment in both the horizontal and vertical alignment to account for imperfection in the alignment and/or spacing of the mounting hardware and allow for alignment of the pegboard within the frame. It is designed to allow use of a single model for both left and right mount points, and as such will be canted outward slightly when aligned to the SKADIS pegboard slots.
Designed to give a four-line wall thickness at a 0.3 layer height and to be printed without supports.