1979-1986 Mustang Shifter Boot Bezel
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a 3D-printable replacement shifter boot bezel/trim piece for 1979-1986 Mustangs with a manual transmission.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 35
- Wydruki
- 0
- Wyświetlenia
- 145
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
While designing a custom bezel for a unique shifter setup in my car, I modeled this, a fully 3D printable recreation of the original Ford piece. The bezel prints in 3 parts- the main body (white in the image) and the two "posts" (red) that insert into the snap-lock retainers in the car. The posts dovetail into the bezel, and I recommend gluing them in place, although it isn't absolutely necessary. The bezel itself has built-in supports (blue in the image) for the tabs on the bottom/rear of the bezel. Snap these supports off after printing.
If you print this on a textured PEI plate, the visible surface as-installed in the car will have that texture and it looks almost like it came that way from the factory.
I recommend .45 extrusion width, .2 layers. Print the parts solid. Parts should orient in the correct way on the build plate when you open them.
I have included the STEP model in case you want to modify anything.