Elgato Streamdeck MK1 (classic) under desk drawer/slider
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Pull out your streamdeck sideways into an angle for easy use
- Ocena
- 5 / 5
- Polubienia
- 42
- Pobrania
- 78
- Wydruki
- 0
- Wyświetlenia
- 1135
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
Print your own angled underdesk slider for your MK1 (classic).
You have two options:
- With a 608 Bearing (nicer pull out)
- With a sliding part (a bit friction but no bearing needed)
Choose the right frame.
If you choose the bearing version just press it on the bearing socket.
Print options:
Print both frame and husk upright!
Husk: With the front down (no supports needed)
Frame: Use tree supports for a good cut out finish.
I used 100% infill on the frame for extra strength.
The husk likes at least 3 walls (more is better).
Wall printing order "outer/inner" for nice tolerances.
0.2mm layers are ok.
Assembly:
- Put bearing on its socket on the frame (slider version doesn't need this step)
- Slide frame into the husk from the back
- Glue the handle on the front of the slide (is basically also the stopper for sliding it in)
- Now screw it under your desk (screw holes are all reachable in assembled condition)
- Give it a like on printables. ;)