Mounting Bracket for Govee Outdoor Lights Pro

What's this thing for?

This part allows you to secure Govee Outdoor Lights Pro to your housing using two screws. I had good luck with gutter screws, which conveniently are available in white.

Why is the 'u'-shaped part where the cable will pass through blocked off?

This model uses built-in supports designed to be removed after the print, either by hand or with pliers. Because these are designed in, your slicer's support option should be disabled. 

Why'd I make this?

I designed this model because I was installing the Govee Outdoor Lights Pro and found that the adhesive backing was not adequate to hold the lights even after I carefully cleaned the surface they were being stuck to. I wanted something I could use to secure the lights to my soffit with gutter screws.

How should I print this?

This should be printed with PETG or ASA, ideally, for best performance outdoors, but generally these won't see direct sunlight, so you might be able to get away with another material.

The part should import into your slicer already in the correct orientation for printing.

These are the settings I used, but other than making sure supports are on there's some wiggle room for the rest.

Perimeters: 4
Top/Bottom Layers: 4
Infill: 40%
Supports: Off

What should I do if I run into problems with the model?

Feel free to leave a comment with suggestions for improvement, questions, or requests for help. I'd be glad to help you to the best of my ability. I'm not on Printables 24/7 but should usually respond in a day or two at the latest.