MonoBlade fanduct system and cover for the SV08 Max
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A toolhead cover and replaceable fanduct system for the Sovol Sv08 Max. Meant to be remixed. High HDT materials only.
- Ocena
- 5 / 5
- Polubienia
- 6
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 282
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- GNU General Public License v3.0
Use ABS-GF, ASA-GF or other Hight temp material.
I modelled from scratch a modular toolhead cover and fanduct for the SV08 Max.
All version have a 23mm opening as opposed to 17mm of the stock fanduct.
v0.7: symmetric air flow and more consistent air pressure at both sides to avoid directional differences to print quality
v0.6: re-enable the bottom front section to decrease fan air leak at the front
v0.5: first version published


Supports an additional MCU fan should you decide to add one.
This is a fan mounted in cover design.Introduces a replaceable fanduct system.
The main feature here. Remix and swap fanducts to your liking!
Bolted on to decrease resonances.
You are no longer need to remix or edit the shroud to experiment with different fanduct.
Feel free to find or make better fanduct designs for the MonoBlade system!
The fan used:
Top: WINSINN 3010 30mm 24V RGB fan https://www.aliexpress.com/item/1005003881965890.html
It is a 0.05A fan. I added it to the front part cooling fan which is at 0.5A for the total of 0.55A, an increase which should be within the capabilities of the board.
Bottom: Original 0.5A 5020 blower from the Sv08 Max toolehad
Other parts needed:
3X M2 heat inserts with 3mm outer diameter and height
other height/length might work too
3X M2 srews with about a 10mm long thread + screw head, there is about +/- 2mm tolerance
2X M1.7 x6 or M1.7x5 self tapping screw for the 3010 minifan.
It stays on without, but helps with resonances.
There are 4 screw holes, so you have an extra two mounting points if needed.
2x M2 x6 or so self tapping screw for the original 5020 blower fan.
Optional 4x 3mm by 2mm round magnets
The clips are strong enough to hold without them, but add them if you see increased resonances

It offers a comparable bridging perfomance to stock. In some cases it looked better to me ™


