Universal Spool Holder! Mounted on top of Frame | Works with 2020 extrusions/or any other frame..
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a 3D printable top spool holder with a removable spool tube thingy and works with almost any frame! 2 x M5 screw
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 16
- Wydruki
- 1
- Wyświetlenia
- 138
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
This is a universal spool holder which you can attach on top of any frame but works best with aluminium extrusions!
BEFORE YOU PRINT PLEASE READ BELOW!
How to install -
Remove all supports and fix the tube in the stand. Then make sure you line up the tube by rotating it so it stays flush with the top surface of the stand. then fix the nut from the other end.

Hardware Needed - 2 x M5 Screws and Nuts (Use T Nuts for extrusions)
Print settings:
10% infill works fine!
WARNING!! Print orientation must stay same as when downloaded!!! If you print the tube vertically then it will easily break! It needs to hold 1kg!
Filament: PLA works fine. Any other filament works good too.
Layer height - 0.15 to 0.2
Supports - Tree.
For easy to remove supports I HIGHLY RECOMMEND using these settings - https://www.reddit.com/r/BambuLab/comments/1coiy6m/guide_how_to_produce_easy_to_remove_supports/
Credit - https://www.reddit.com/user/TotalWarspammer/
