V1.1 Silica Recharge Basket for Filament Dryer and CFS / AMS.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Recharge Basket that doesn't let small broken Silica Beads fall out like most designs.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 286
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
Are you tired of trying to recharge your silica beads in the microwave? I sure am.
Do you have a filament dryer? A Space Pi or similar?
I was tired of trying to recharge silica in the microwave. They get hot, sticky, and its a tedious process transferring them back and forth. I have a Space Pi Filament dryer, why not use it?
What makes my design so significant?
- Super simple print. its flat, its thin, and its not solid. Warping is minimal even with ABS!
- Traditional Silica containers are printed upright as a single part. The print is complicated with a lot of retractions. This print is simple, and minimal retractions.
- Traditional Silica containers have larger, un-uniform holes that don't maximize air flow. This design is almost 100% perforated! Which means great air flow. And the best part? The perforations (holes) are small enough block almost all the silica beads in comparison to others!
Assembly:
Assembly is simple. It just requires construction like a puzzle. Then each piece is held together with M3 x 12mm screws. A total of 24 screws are required.
Use:
Drying parameter suggestions: 70-75C for 24hrs.
