Fuji 23mm F2 and 35mm F2 Lens Hood and Cap (two versions)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Bayonet mount lens hood and cap for Fuji 35mm F2 and 23mm F2 lenses. Two versions provided.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 205
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial
Here are two versions of the same lens hood, one with a magnetic cap, the other with a snap-action cap. These have been tested on both the Fujifilm 35mm F2.0 and the Fujifilm 23mm F2.0 lenses. No vignetting has been detected. They are both bayonet mount.
Caution is advised re which surface of each part is laid on the print bed, shown in the photos. All parts should be printed with 30% infill or more. I printed with PLA (not fiber filled), but if you need greater heat resistance, use PET-G.
One version uses small 5mm diameter by 1mm thick neodymium magnets press fit into pockets, the other has a spring-clip design, fully 3d printed. The magnets are available through Amazon and others. For example: https://www.amazon.com/dp/B0C9GLYGDR
For the magnet version:
Be careful to orient the magnets so that they will attract (not repel), and that they are the same on both sides of the barrel. Work carefully, they're impossible to remove once inserted.
For the cap, insert one magnet into each of the "ears", pressed in to be flush
For the hood, insert two magnets into each recess on the back of the barrel.
If you're concerned about the magnets falling out, put a small drop of cyanoacrylate into the recesses before inserting the magnets.
For the spring-clip version, after printing slide the "latch" part through the slot in the cap, then affix in place using the "pin".
I honestly don't have a favorite, they both work well.
Incidentally, these both allow a filter or two to be on the lens without interference.
Comments are welcomed.