Self-Draining Sponge Holder | Wave Drip Tray
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Minimalist drip tray for sponges or soap. Features wave ridges for airflow and a drainage spout. Available in 2 sizes.
- Ocena
- 4,854 / 5
- Polubienia
- 1665
- Pobrania
- 9943
- Wydruki
- 45
- Wyświetlenia
- 25 535
- Oceny
- 41
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial
🚨 UPDATE: Check out the improved V2 here:
BOM: Printed with ROSA3D High Speed PLA Gray
Say goodbye to soggy, smelly sponges. This drip tray features a functional wave pattern on the bottom that lifts your sponge (or soap bar) slightly up, allowing air to circulate underneath and water to flow away freely.
Key Design Feature: The front of the holder has a dedicated drainage spout/opening. Position this edge over your sink, and excess water will naturally drain out, keeping your countertop dry and your sponge hygienic.
The Set Includes 2 Sizes:
Standard (95x65mm): Perfect for standard kitchen sponges. Fits items up to ~95x65mm comfortably.
Large (115x85mm): Great for larger scouring pads or big bars of artisanal soap. Fits items up to ~115x85mm.
Printing Instructions:
Material: PETG or ASA are recommended because they handle moisture and cleaning chemicals better than PLA (though PLA works fine for a while).
Supports: None required.
Infill: 15-20%.
Watertight: Ensure your "Flow" is calibrated or increase wall count to 3 to ensure the tray doesn't leak.