V-Core 4.0 IDEX fan shroud upgrade (V-Core4.1)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The massively improved fan shroud from V-Core 4.1 IDEX is adapted onto the V-Core 4.0 toolhead.
- Ocena
- 5 / 5
- Polubienia
- 19
- Pobrania
- 54
- Wydruki
- 1
- Wyświetlenia
- 388
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The massively improved fan shroud from V-Core 4.1 IDEX is adapted onto the V-Core 4.0 toolhead.
Upated models: Now with beacon cable routing and constraints. The beacon cable is wired as shown in the following picture and secured using a zip tie.
Attention! For Rapido UHF version, the beacon is mounted 3mm closer to the hotend than on stock 4.0 toolhead. For Chube it is mounted 2mm further away. This has to be adjusted in RatOS config, please use the following config in printer.cfg (Chube value = 24.7, Rapido value = 19.7):
Also the Z-constraints from V-Core 4.1 must be used on all z axes, as the old ones interfere with the fan shroud!
Currently supported hotends:
-Rapido UHF
-Chube Air
Printing with 0.4mm nozzle and at least 4 - 5 walls @ 20% infill is recommended. No support required, they are built in already. The Chube Air version additionally requires the adjusted front part, which also allows for the Chube to be removed without disassembling the toolhead.
The following parts have to be installed:
14 x heat insert M3
2x M3x10mm cap head screw
1x M3x12mm cap head screw