1 / 2
DuPont and Jumper Wire Holder for Multiconnect Wall Systems (OpenGrid, HSW, GOEWS, Multiboard, SKADIS) — zdjęcie 1
1 / 2

DuPont and Jumper Wire Holder for Multiconnect Wall Systems (OpenGrid, HSW, GOEWS, Multiboard, SKADIS)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A jumper wire holder. This has holes on the side so you can adjust and push them back easily with no mess!

Ocena
0 / 5
Polubienia
12
Pobrania
47
Wydruki
0
Wyświetlenia
302
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution — Noncommercial

This is an overbuilt jumper wire holder that seeks to contain the mess. All other solutions I was seeing were Gridfinity, but I really wanted a vertical solution. The wires stay put very well and don't jump out, and it's very easy to simply put your finger or a pen in the side and push all of the wires back if something messy is about to happen. 

This is tested on OpenGrid, but it should work on all other wall systems supporting Multiconnect. Keep in mind that you can use offset Multiconnect to get the PERFECT length for your wires and not have it too tight or slack.

Printed without supports at 0.3 Draft on a Prusa MK3S+.

Thanks to DavidD for Multiconnect!

Tagi