Tamiya M03/FF02 Center Extension 257mm Wheelbase
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Center section to make your Tamiya M03 into Tamiya FF02. Use with Tamiya TL01 suspension arms.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 98
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Public Domain
Want to make your old or extra Tamiya M03 into a Tamiya FF02?
This is the way, use these parts with Tamiya TL01 suspension arms to do it.
Copied part from a original Tamiya FF02, center section is made so it provide good place to put ESC and receiver. I used this for a long time, so it's tested and can withstand race-use printed in PETG with 5 walls and 5 top/bottom and 40 % cubic infill. Also included shock towers and upper arms. Suspension arms is found on several 3D print sites if needed.
Used M2.5x16mm bolts on plate under extension, predrilled holes in sides.
Front I used M3x8mm and rear M3x16mm.
If there are other 3D printed parts from this Tamiya FF02 you want, then tell me and I will share them.
I used a old race-worn chassi that I was about to throw out to build this, cut some 5mm carbon tubes I used in gearbox and added a old bevelgear diff. Was pretty successful, if you ask me!
Do what you want with files, use them, print them, sell them, anything. I don't care!