Modular PlayStation (CD/DVD/Bluray/Steelbook) Case Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A modular wall mount for PlayStation cases. Supports all console generations (1 through 5) and variants.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 180
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Open Community License v1.1 + General Attribution v1
I wanted to store my complete Gran Turismo collection in a sleek, mechanical-looking mount, so I decided to design my own. I made it as modular as possible, and tried to make all parts printable without any support, but had to compromise on the actual case holders. The only real limitation is that it has to be used in 2 columns, so cases can be slided in from each side while keeping the mount looking good.
The design is printed with PETG in mind, and my own mount was printed fully in PETG.
I recommend using supports on the case holders, but you can try your luck without any supports as well.
Each row consists of:
2 Bases (which support 20mm wide double sided tapes)
Side Connector
Middle Connector
Case Holders for each specific case variant, in left side and right side versions.
Top and bottom screws require washers, which are provided as models. The top row can also use the "Edge Base" variant, but a normal or wide base will do just fine.
I recommend putting the connectors below the case holders when assembling the mount. It should work fine the other way around as well (connectors on top of the holders), but that's just not how it was designed to work.
4.6mm x 5.7mm Heated inserts (for the base holes) and M3 10mm screws are needed to assemble the mount.
If you like my work, consider making a donation by clicking here, thank you!