YT Capra MKIII External Brake Mounts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
All the necessary parts required to convert brake lines on a YT Capra MKIII mountain bike to externally routed.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 52
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
YT Capra MKIII External Brake Routing Conversion Kit
About This Project This is a complete set of 3D printable mounts to convert the brake lines on a YT Capra MKIII mountain bike from internal to external routing. I originally designed these to solve the issue of internal cables rubbing through their housings. As a major bonus, external routing makes routine maintenance significantly easier, allowing you to remove the brake system entirely without having to disconnect lines or re-bleed the brakes.
Hardware Requirements
Front Cable Mounts (CMIII_4): You will need your own screws and washers to clamp these through the front brake mounting holes.
All Other Mounts: These are designed to re-use the factory mounting screws.
Print Settings
Infill: Print at 100% infill for maximum structural strength.
Material: PETG, ABS, or ASA are highly recommended over PLA for outdoor durability, impact resistance, and UV resistance.
Safety & Liability Disclaimer These files are provided "as-is" for personal use. Mountain biking is an inherently dangerous sport, and these are DIY, 3D-printed parts that secure critical braking components. By downloading, printing, and installing these mounts, you assume all risks and liability associated with their use. Always test your equipment thoroughly and inspect your 3D-printed parts regularly for wear or cracking.