Greaseweazle v4.1 case for 3.5" disk drive (improved)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Case for a Greaseweazle v4.1 interface board and a 3.5" floppy disk drive. Improved design.
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 84
- Wydruki
- 0
- Wyświetlenia
- 377
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Case for a Greaseweazle v4.1 interface board and a 3.5" floppy disk drive to go with it.
Improved the original design in several ways: Added a power or activity LED hole (although I also left a version without it), the back panel now screws from the back instead of the sides and the board mounts securely with rails into the main case instead of screwing to the back. The bottom screw holes are deeper to allow use of the more common and shorter screws that are used in a lot of old drives.
I also made TPU feet that insert into the bottom screw holes to prevent the case from slipping around.
The "gw-divider.stl" fits between the screw posts (it should be installed upside down from how the model is set up for printing) to separate the cable compartment from the drive, specially useful so the ribbon cable doesn't rub against the flywheel of disk drives that have it exposed on the bottom. Shouldn't be necessary if yours is not one of those.
As the original, print the case facing down and probably without supports, but the TPU feet should be printed sideways to prevent layer separation when you try to remove them.
Probably quite easy to adapt for a v4 Greaseweazle board too but I don't have one for reference.