1 / 4
MatixBuilt XR Rails to TFL XL Drop Top Fender Top Piece Adapter — zdjęcie 1
1 / 4

MatixBuilt XR Rails to TFL XL Drop Top Fender Top Piece Adapter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Mini fender, mud guard, and DTF base piece, all in one! For MatixBuilt rails with BTG tire.

Ocena
0 / 5
Polubienia
1
Pobrania
22
Wydruki
0
Wyświetlenia
122
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Ideas
Licencja
Creative Commons — Attribution — Noncommercial

Mini fender, mud guard, and DTF base piece, all in one! For MatixBuilt rails with BTG tire. Larger tires or offset (raised/lowered position) may require modification to the riser.

This interfaces with the GT XL/BTG fender, not the regular small one.

Printing Instructions

  • Print it flat in the orientation it will sit on the rails, ideally.

  • PETG has served me well in terms of strength and being flexible enough to take hits.

  • 50% or comparable infill

  • Supports enabled (I used organic for the support pattern)

    • Support the DTF interface (the little lip up top)

    • Support the "roof" that sits over top of the footpad for the Stompies version

    • The rest does not need supports

  • Optional: Build Plate Adhesion enabled (I used brim for the adhesion type)

  • Optional: 3 or more brim lines, to keep things adhered and sturdy

Once configured:

  1. Take ‘em off your print bed when they’re done and remove the supports.

  2. Install on your board. It should fit right over any stock (8mm) clearance height foot pads, or a rear pad with up to a 3mm backer plate.

  3. Hardware:

    1. Needs 2 x 1.25" #10-32 countersunk screws for the screw holes toward the wheel

    2. Needs 2 smaller #10-32 countersunk screws for the footpad holes. Size to your needs.

Tagi