1 / 4
MatixBuilt XR Rails to TFL XL Drop Top Fender Top Piece Adapter — image 1
1 / 4

MatixBuilt XR Rails to TFL XL Drop Top Fender Top Piece Adapter

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Mini fender, mud guard, and DTF base piece, all in one! For MatixBuilt rails with BTG tire.

Rating
0 / 5
Likes
1
Downloads
22
Makes
0
Views
120
Reviews
0

Updated at source:

Model information

Category
Other Ideas
License
Creative Commons — Attribution — Noncommercial

Mini fender, mud guard, and DTF base piece, all in one! For MatixBuilt rails with BTG tire. Larger tires or offset (raised/lowered position) may require modification to the riser.

This interfaces with the GT XL/BTG fender, not the regular small one.

Printing Instructions

  • Print it flat in the orientation it will sit on the rails, ideally.

  • PETG has served me well in terms of strength and being flexible enough to take hits.

  • 50% or comparable infill

  • Supports enabled (I used organic for the support pattern)

    • Support the DTF interface (the little lip up top)

    • Support the "roof" that sits over top of the footpad for the Stompies version

    • The rest does not need supports

  • Optional: Build Plate Adhesion enabled (I used brim for the adhesion type)

  • Optional: 3 or more brim lines, to keep things adhered and sturdy

Once configured:

  1. Take ‘em off your print bed when they’re done and remove the supports.

  2. Install on your board. It should fit right over any stock (8mm) clearance height foot pads, or a rear pad with up to a 3mm backer plate.

  3. Hardware:

    1. Needs 2 x 1.25" #10-32 countersunk screws for the screw holes toward the wheel

    2. Needs 2 smaller #10-32 countersunk screws for the footpad holes. Size to your needs.

Tags