IKEA ALEX Anti-Sag Fix
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This simple 3D-printed support clip reinforces IKEA ALEX drawers and helps fix sagging or bending.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 124
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
If you’ve used the IKEA ALEX units for a while, you’ve probably noticed the drawer bottoms starting to sag, especially under heavier loads. This small reinforcement clip solves that problem by adding extra support.
It mounts underneath the drawer, keeping everything straight and level while eliminating the “hanging” look and improving long-term stability.
Unlike other fixes for this on Printables, this design improves load transfer. Many alternatives place screws parallel to the load path, which can cause them to loosen or pull out over time. This design avoids that weakness for a stronger, more reliable hold.
For larger drawers, I recommend using two clips per drawer.
Materials Needed per Clip
Printed Support Clip
3,0x12mm Wood Screw
1x M3 Nut
1x M3 Flathead Screw 6-10mm Length
3mm Drill
Print Instructions
Print laying flat, oriented on its side with support enabled. For more strength, increase the vertical shell perimeters to 3-5.
Assembly
Remove the drawer from the cabinet
Ensure the bottom panel is seated correctly
Place the Clip in the desired position (see images)
Drill a hole through the bottom panel
Insert the M3 Screw from inside the drawer through the hole and mount the clip from below using the M3 nut.
Firmly press the back panel onto the bottom panel and secure it in place using the wood screw.
Done!