1 / 1
Toyota Proace Sliding Door Striker Catcher (2015) - 3D Printed Replacement — zdjęcie 1

Toyota Proace Sliding Door Striker Catcher (2015) - 3D Printed Replacement

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The sliding door striker receiver on the Toyota Proace (2015, L2H2)

Ocena
0 / 5
Polubienia
0
Pobrania
10
Wydruki
0
Wyświetlenia
73
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Share Alike

The sliding door striker receiver on the Toyota Proace (2015, L2H2) is a plastic part that tends to crack over time, causing the sliding door to not latch properly. This is an exact replacement part that can be printed at home and installed without any modification.

This part also fits the Citroën Dispatch and Peugeot Expert of the same generation (2007–2016) due to the shared platform.

Tested and working perfectly on my own Proace L2H2.

Compatibility:

  • Toyota Proace 2007–2016

  • Citroën Dispatch 2007–2016

  • Peugeot Expert 2007–2016


Print Settings:

  • Material: PETG (recommended for durability and heat resistance) I tried ABS, but it tends to crack at the layer lines. 

  • Infill: 50%+ recommended for strength

  • Infill pattern: Gyroid or cubic

  • Perimeters: 4+

  • Supports: Check before slicing

  • Layer height: 0.2mm


Notes: Do not print in PLA — it will deform in a hot car. PETG or ASA are the right materials for this application.

Tagi