Sugoi Body for Dukedoks Cramer RC Truggy car
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Just another option for a body for your amazing Cramer RC Truggy.
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 257
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
Introduce your model, create build instructions and add print tips... OK!
Introduction
This another option for body of cramer RC truggy:
https://www.printables.com/model/1274256-cramer-truggy-rc-4x4-full-3d-printed
Also, I created a small project for the lights using some WS2812 LEDs and a ESP32-S2 mini to control them.
Build Instructions
Hardware used:
Front lights: 2x M3x20 screws / 2x M3 nuts
Front bumper: 2x M3x25 screws / 2x M3 nuts
Rear lights: 2x M3x16 screws / 2x M3 nuts
Rear bumper: 2x M3x20 screws / 2x M3 nuts
Locker button: 5.6 x 11 spring / M3x16 screw
Spoiler: 4x M3x6 screws
The body was design to use the same screws from chassis, so perhaps you need some of them longer
You can find the project to flash in a ESP32 MCU in this repository: https://github.com/JulioSugaya/sugoi-rc-lights-v1
The LEDs used in this projects are WS2812 8 channels which I put 2 for each light, you can solder 2 in sequence and use them as 16 channels.
Btw, there is a little case to fix this ESP32 in the chassis among the model files.
Print Tips
Here below there some advice which worked for me.
Model | Filament | Support? | Raft? |
cramer_sugoi_body-botton | PLA | Yes | Yes |
cramer_sugoi_body-top | PLA | Yes | Yes |
cramer_sugoi_body-front | PLA | Yes | No |
cramer_sugoi_body-rear | PLA | Yes | No |
cramer_sugoi_body-spoiler | PLA | No | Yes |
cramer_sugoi_front_bumper | TPU | No | No |
cramer_sugoi_rear_bumper | TPU | No | No |
cramer_sugoi_front_lights | PETG | Yes | No |
cramer_sugoi_front_lights_glass | TransparentPETG | Yes | No |
cramer_sugoi_rear_light | PETG | Yes | No |
cramer_sugoi_rear_light_glass | TransparentPETG | Yes | No |
cramer_sugoi_body-esp32-box | PLA | No | No |