EcoFlow WAVE 2 / 3 Duct Connector Caps
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Based on Kraemer's design, these allow you to cap the ports if your install is a permanent one.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 110
- Wydruki
- 0
- Wyświetlenia
- 598
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Share Alike
Special thanks to Kraemer for his original work. I'm using his connectors in a conversion trailer, where my ducting ports run through the floor. Since those holes are permanent, I needed a way to cap them off when they’re not in use.
I sliced these parts in PrusaSlicer and printed them using PLA. No special settings were required, though I couldn’t avoid using supports. I found that orienting the part with the twist handle facing down on the build plate produced the best results. I used “Snug” style supports and painted them onto the overhangs (13°). See the included screenshot. The three slots were easy to clean up afterward with a utility knife.