EcoFlow WAVE 2 / 3 Duct Connector Caps
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Based on Kraemer's design, these allow you to cap the ports if your install is a permanent one.
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 110
- Makes
- 0
- Views
- 598
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Share Alike
Special thanks to Kraemer for his original work. I'm using his connectors in a conversion trailer, where my ducting ports run through the floor. Since those holes are permanent, I needed a way to cap them off when they’re not in use.
I sliced these parts in PrusaSlicer and printed them using PLA. No special settings were required, though I couldn’t avoid using supports. I found that orienting the part with the twist handle facing down on the build plate produced the best results. I used “Snug” style supports and painted them onto the overhangs (13°). See the included screenshot. The three slots were easy to clean up afterward with a utility knife.