Starlink Gen 3, Standard 4 (V4) Pole Mount | Multiple Pipe Sizes

This is a remix of the original Starlink Gen 3 pole mount with several quality-of-life improvements.

NEW Update 9. 8. 2026
🇺🇸 Added US standard NPS pipe sizes (1/2” – 1-1/2”)!

If you like my work please support me. :-) Buy me coffee at ko-fi.

Compatibility:

✔ Starlink Gen 3
✔ Starlink Standard 4 (V4)
✔ Starlink Standard 4X (V4)

All of these kits use the same dish and mounting interface.

What's improved?

• Better tolerances for a tighter and more precise fit of the Starlink antenna and pole adapter

• Added slots for easier removal of the retaining pins (retainers) that hold the pole adapter in place

Available in the following pole diameter variants:

Metric pole diameters:

• 20mm, 25mm, 28mm, 30mm, 35mm, 38mm, 40mm

US standard pipe sizes (NPS):

• 1/2” NPS – 21.34 mm OD

• 3/4” NPS – 26.67 mm OD

• 1” NPS – 33.40 mm OD

• 1-1/4” NPS – 42.16 mm OD

Note: NPS sizes are nominal pipe sizes – the actual outside diameter (OD) is shown above. Choose the model according to your pipe size.

Each variant is available for both M6 and M8 bolts.

Need a different size? Message me. :)

Printing and assembly

Choose your bolt size (M6 or M8) and select the matching base and pole adapter for your pole diameter!

Once printed, clean up the bolt holes in the base print – some light post-processing may be needed for a clean fit - a single bridging layer is included in the bolt holes for better printability.

The mount can be used in two orientations:

• Nuts on the outside, bolts from inside the mount

• Bolts inside the mount, nuts on the outside

Preferred orientation: nuts on the outside – see photos.

Hardware needed (per mount):

• 4× M6 or M8 nuts (preferably nyloc/self-locking)

• 4× M6 or M8 bolts, 25mm length

• Large washers + spring washers

• Worm drive hose clamp (choose the appropriate size for your pole diameter)

Print settings

• Material: ASA recommended, PETG also works

• Infill: 25% minimum

• Perimeters/walls: 6

• Layer height: 0,2mm (better for tolerances around pole)

Tested

• All models printed in ASA with the settings above

• 28mm variant personally tested and tolerances confirmed working

• Other sizes not physically tested, but tolerances are set to work well across all variants