Cover for Pipe Clamp on Wall (heating tube)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple snap-on covers to hide ugly radiator pipe brackets commonly found in old apartments with exposed pipes.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 111
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a simple solution to cover up those ugly radiator pipe brackets commonly found in many old apartments. You can simply snap the covers over the pipe clamps. In most cases, that’s all you need to do.
However, if there are two clamps side by side at different heights, you can compensate for this by inserting the included C-ring. Before printing, you should measure the offset and then scale only the height of the C-ring according to your needs, or just stack several thin ones.
You should also measure the diameter of your pipe and clamp before printing and scale the design if necessary. The cover has a slightly asymmetric opening so that the typical clamp screw can stick out. This should work for most clamps similar to those shown in the photos.
DIMENSIONS / SPECS
Cover outside: cover hight= 34 mm // cover diameter= 40 mm
Cover inside: max. clamp hight= 30 mm // max. clamp diameter= 37 mm
Pipe diameter: 22 mm
PRINTING NOTES
3mf file was created in Bambu Studio, its compatible with most slicers
100% infill recommended because of thin wall thickness
PLA Filament should be fine, but might deform a bit due to heat.