YAHA – Yet Another Hotend Adapter (Bambu A1/H2 → AD5X)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Combined AD5X adapter and spacer for Bambu A1/H2 hotends. One-piece design, easy install, no supports needed.
- Ocena
- 0 / 5
- Polubienia
- 49
- Pobrania
- 208
- Wydruki
- 0
- Wyświetlenia
- 785
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
YAHA – Yet Another Hotend Adapter
This is a combined remix of two existing models:
Both original parts approached the adaptation problem in different ways — one focused on mounting and alignment, while the other addressed spacing and positioning.
This design combines the strengths of both approaches into a single, unified component, aiming for:
maximum rigidity
improved stability
simpler installation
Features
One-piece design (adapter + spacer combined)
Compatible with Bambu A1 / H2 hotends
Mounts directly to AD5X toolhead
No supports required
Improved structural strength compared to multi-part setup
Printing
Recommended settings:
Material: PETG
Infill: 100%
Layer height: 0.2 mm
No supports required
The part is designed to print cleanly without overhang issues.
Notes
Fit should be tight and precise (as with the original adapter design)
Minor scaling or XY compensation may be needed depending on printer calibration
High-flow hotends may still have compatibility limitations on AD5X setups (3D Printer Files | 3D GO)