Snapmaker U1 ACE Pro USB-C Rear Cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
USB-C rear cover for ACE Pro to connect Snapmaker U1 without cutting or modifying the original housing.
- Ocena
- 3 / 5
- Polubienia
- 20
- Pobrania
- 61
- Wydruki
- 0
- Wyświetlenia
- 638
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Anycubic Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
Replacement rear cover for ACE Pro with integrated USB-C port for Snapmaker U1 connection.
No cutting.
No drilling.
No permanent modifications.
The cover installs using the original screws and keeps a clean factory-style appearance.
Only 3 pins are used:
D+
D-
GND
Please use the included pinout image carefully.
The other pins are NOT connected.
Community Projects
Tested successfully with both projects:
Huge thanks to the developers who made ACE Pro support for third-party printers possible.
This model only provides the physical USB-C mounting solution.
Firmware/software setup is handled separately through the projects above.
Compatibility
Tested on first-generation Anycubic ACE Pro
Snapmaker U1 verified working
Compatibility with other ACE revisions is unknown
USB-C Connector
USB-C connector example used in this build:
AliExpress USB-C Connector Example
Assembly
Print the rear cover
Install and glue USB-C connector into the cover
Solder D+, D- and GND
Install rear cover
Follow firmware/software setup guide
I used 2-component epoxy glue for mounting the connector.
Print Settings
PLA / PETG / ABS
0.2 mm layer height
Standard supports enabled
Supports are only needed for the screws openings
Supports remove easily
Print time around 20 minutes
Notes
USB connector dimensions may vary slightly depending on supplier
Test fit before final gluing
Use at your own risk
Important Installation Notes
Please carefully review all assembly photos before installation.
The USB-C connector must be glued exactly in the position shown in the photos.
Wire routing must follow the assembly photos as closely as possible.
The model was verified against the original Anycubic Ace Pro (v1) cover.
A printed verification template was used to confirm mounting hole alignment and USB-C opening position.
The USB-C opening position was intentionally selected to provide proper clearance for the connector, PCB and wiring.
If your assembly differs from the photos, connector alignment may also differ.
STEP files are available upon request.