Sunflower Pen Cup — Petal Crown + Gothic Quatrefoil Body
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Tall pen / marker cup with an 18-petal sunflower crown at the rim and a brick-grid of gothic quatrefoils…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 31
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
Tall sunflower-themed pen / marker / brush cup. Two design notes make it more than a plain cylinder:
Petal crown at the rim — 18 stretched-ellipsoid petals splay outward from the top of the wall. From the side the silhouette reads as a sunflower head; from above as a sun. Petals merge at their bases (no gappy gear-tooth look) and lean outward so the inside of the cup stays straight-walled.
Gothic quatrefoil grid engraved 0.8 mm deep into the body — 14 columns × 4 rows of cathedral-rose four-lobed motifs in a brick-staggered pattern. Catches accent paint or a wash nicely if you want to highlight the pattern.
Dimensions:
90 mm outer diameter, 100 mm tall.
2.6 mm wall, 3.0 mm floor — heavy enough not to tip when full of pens.
Petal tips extend ~9 mm above the rim — total height with crown ~109 mm.
Print profile (Bambu Lab P2S, PLA, 0.4 mm nozzle, 0.2 mm layer):
Flat bottom on the bed, NO supports.
Petals' lower hemispheres are ~30° overhangs (designed this way on purpose) — print cleanly without supports on any modern FDM.
3 perimeters, 15 % gyroid infill, no brim.
~6-7 h, ~85 g PLA depending on slicer settings.
Source .scad included — every dimension is a top-of-file parameter:
outer_r,height,wall_t,floor_t— envelope.petal_n,petal_W_tangent,petal_Z_vertical,petal_tip_x_out— crown shape (fewer/wider petals, taller, more splay).qf_rows,qf_cols,qf_lobe_r,qf_engrave_d— quatrefoil density and depth.
Render variants from the bundled source with:
openscad -o sunflower_pen_cup.stl sunflower_pen_cup.scad
Single-colour print as shipped. For a two-tone look (gold petals on a darker body) you can split the crown out by editing the .scad — the crown() and body_with_quatrefoils() modules are already separate, just emit each to its own STL and assemble in Bambu Studio.
