Creality Ender 3 Light Bar Brackets - Normal & Mirrored
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A printable model of the plastic brackets that come with the official Ender-3 light bar, both normal and mirrored.
- Ocena
- 5 / 5
- Polubienia
- 9
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 195
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
This is a 3D model of the side brackets found on the official Creality Ender 3 light bar upgrade kit. I designed this for three reasons:
The original plastic mounts are prone to cracking, especially under tight screw tension.
The original mounts were limited to being mounted on the top extrusion, but I already had KevinAkaSam's Belted Z mod installed there.
I wanted a mirrored design so that the cables could be run down the other side of the printer.
This design addresses these issues by making the mounts easily reprintable in any material you want. It also uses screws and T-nuts to mount instead of a press fit. Finally, I have included the aforementioned mirrored design along with the normal design in case you would like to route the cables differently.
Printing
As this design will be screwed into the printer, I would recommend printing with more walls and infill than usual. Additionally, if your printer is in an enclosure, more temperature-resistant materials such as PETG or ABS/ASA are ideal. I printed mine in PETG, and it has held up despite my printer being in the Creality tent enclosure.
Assembly
This design requires no extra hardware to mount where the original mounts are meant to go, but it requires 2 M5 screws and 2 M5 T-nuts to mount it on the side extrusions rather than the default top ones.
When swapping the power switch, it may be hard to pop out of the original bracket; it has two clips on the top and bottom inside the bracket that must be pressed together to slide the switch out, and this can be a bit tricky. However, it is possible, allowing you to put the switch in the new design.
License
This design is shared under the CC BY 4.0 license, meaning you can share, adapt, and sell copies of this design as long as you give proper attribution. This requires you to include the name of the creator (Ethan Bayer), a license notice, a link to the original material, and, optionally, the title.
Example
“Creality Ender 3 Light Bar Brackets - Normal & Mirrored” (https://www.printables.com/model/1721367-creality-ender-3-light-bar-brackets-normal-mirrore/) is designed by Ethan Bayer and shared under a Creative Commons Attribution (CC BY 4.0) license (https://creativecommons.org/licenses/by/4.0/).