Shift collar bushings for Swift Sport (ZC33S)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replaces OEM rubber bushings for more solid feel gear selector feel Same design as aluminium kits available for sale.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 164
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
These are the equivalents of the aluminium sets you see for sale such as https://www.rhdjapan.com/tm-square-shift-collar-set-swift-sport-zc33s.html
These improve overall gear feel and make it feel more positive/clicky.
Plastic may not be as solid as aluminium but it's still a marked improvement on the soft rubber ones, especially when using a strong filament with 100% infill.
Installation
You will need to refer to the respective instructions for the other kits or service manual if available
Print Settings
Material: ABS, ASA etc. - Something very rigid and that can handle high temps (especially for the external ones)
Infill: 100% - It needs to be quite solid and they are relatively small so not much filament used
Layer-height: 0.24 is probably fine, smaller might give you more strength?
Supports: None
NOTE:
I have not tested the internal gear selector bushings as I had aluminium ones on hand - but they were used as a reference and should work
I have however used the external bracket ones in ASA for well over a year with no issue.