Mudguard extension flap for a crescent bicycle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mudguard extension for 45mm wide, 16mm deep rear mudguard with M5 bolt hole.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 43
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution
Measure your mudguard width and depth before printing. Slice a thin section of the fender and check fit before printing complete fender. This is made for a 45mm wide profile which is about 16mm deep. Attachment should be done with the same bolt that holds the fender in place. Mine used a short M5 bolt which I had to swap to a longer one.
2 models:
The original crescent mudguard had a hole in it for a mud flap. Distance between the mudguard hole centers was about 52mm and so I made 2 models, one with a pin which slots into this hole and another which doesn't have the pin.
Printing:
Print sideways for extra strength.
Recommending supports due to difficult geometry, brim could also be useful.
Supports may be difficult to remove as the curvature of the fender causes a curved support surface.
UV resistant filament, petg, tpu, etc.