Mudguard extension flap for a crescent bicycle
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Mudguard extension for 45mm wide, 16mm deep rear mudguard with M5 bolt hole.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 5
- Makes
- 0
- Views
- 44
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution
Measure your mudguard width and depth before printing. Slice a thin section of the fender and check fit before printing complete fender. This is made for a 45mm wide profile which is about 16mm deep. Attachment should be done with the same bolt that holds the fender in place. Mine used a short M5 bolt which I had to swap to a longer one.
2 models:
The original crescent mudguard had a hole in it for a mud flap. Distance between the mudguard hole centers was about 52mm and so I made 2 models, one with a pin which slots into this hole and another which doesn't have the pin.
Printing:
Print sideways for extra strength.
Recommending supports due to difficult geometry, brim could also be useful.
Supports may be difficult to remove as the curvature of the fender causes a curved support surface.
UV resistant filament, petg, tpu, etc.